Rice-lake Counterpart Configurable Counting Indicator - Inst User Manual download pdf (Page 72)

66 Counterpart Counting Scale Indicator

On the Counterpart

Use the following steps to set up WeighVault on the Counterpart side.

1. Enter menu settings and go to Ethernet.

2. DHCP should be set to Off.

3. Set the IP address 192.168.0.1 (this should be in the same range as the computer side, but the last digit is

different. (If setting your system, check with your network administrator.)

4. Set the subnet mask — 255.255.255.0.

5. Set the default gateway, DNS Pri, DNS Sec — no changes.

6. Set the local port — 10001.

7. Set the remote IP address — 192.168.0.02 (this is set same as computer above).

8. Set the remote port — 5466.

9. Set the Vault — set onboard.

10. Set up softkey — Code.

11. IN/OUT softkey — for in/out inventory setup

5.6.2 Using WeighVault

Once the above criteria have been met, IDs can be entered into WeighVault and saved on the PC’s hard drive. The

Edit Product dialog box in

Figure 5-3 shows ID parameters that can be saved in WeighVault.

For testing purposes, enter a few part numbers and click Save Changes to Database.

Figure 5-3. WeighVault Edit Product Dialog Box

To access a saved ID from WeighVault over the network connection,

1. Using the Counterpart front panel, press the CODE key.

2. Enter an ID CODE value.

3. Press the TARE (Enter) key. The ID CODE is loaded and ready to use.

If the demo feature is complete and not being used permanently with WeighVault, go to your network settings

and turn off the Assign IP Address feature.

Note

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 111 112

No comments

Rice-lake Counterpart Configurable Counting Indicator - Inst User Manual Page 72