Rice-lake Counterpart Configurable Counting Indicator - Inst User Manual download pdf (Page 17)

Installation 11

2.6.1 Dual Channel Units (S-XD Base)

For units that have dual channels, connect cable from the 14 pin connector to J1 and J2. If not using a dual base,

remove the J2 connector as shown in

Figure 2-8. Trim back the wires and tape.

Figure 2-7. J2 Connector Location

2.6.2 Dual Channel – Remote Scale Setup

For units that have dual channels and want to set up a scale remotely, use the following steps:

1. Remove the connector from the parts bag (included).

2. Wire per the load cell wiring code.

3. Plug into the J2 connector on the CPU board (example shown in Figure 2-7).

4. Set up the soft key - Scale Select (see Section 3.7 on page 27).

Figure 2-8. Remove J2 Connector if Using Single Base Scale or Only Single Base on a Dual Base

2.7 Wire Specifics

Wires connecting to J1, J2, J3, or J4 should adhere to the following specifications:

Wire Range Wire Strip Length

28~12 AWG stranded or solid wire 5~6 mm (3/16" ~ 1/4")

Table 2-2. Wire Specifications for Connectors

Shown connectors shipped

from the factory.

Remove connector off of J2

and tie off two wires.

J1 connector

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

No comments

Rice-lake Counterpart Configurable Counting Indicator - Inst User Manual Page 17