Rice-lake Star SP298 Series Programmers Manual User Manual download pdf (Page 7)

Available DIP switch settings (Parallel Interface)

The following table shows all the possible settings for the DIP switch. The

factory default settings are ON for switches 1 through 7 and OFF for switch 8.

A reset can be performed with pin 31 on the interface by setting DIP switch 1 to

ON (the factory default setting).

In addition, when a reset can be performed with pin 31, setting DIP switch 2 to

OFF sets up the unit to perform a reset when pin 31 and pin 36 are “LOW”.

*1: Never set switch 7 to OFF at the same time that switch 8 is set to ON.

Switch Parameter ON OFF

Pin 31 / Pin 36 Reset Signal See table below.

Not used (Always ON)

Command Emulation See table below.

Reset Signal Switch 1 Switch 2

Pin 31 is enabled. ON ON

Pin 31/Pin 36 are enabled. ON OFF

Disabled OFF ON

Disabled OFF OFF

Command Emulation Switch 7 Switch 8

Star mode ON ON

ESC/POS (TM-295) ON OFF

ESC/POS (TM-290) OFF OFF

Not used (*1) OFF ON

1 2 3 4 5 6 7 8 9 10 11 12 ... 78 79

No comments

Rice-lake Star SP298 Series Programmers Manual User Manual Page 7