
320IS Installation Manual - Configuration 21
3.2.3 Front Panel Configuration
The 320IS indicator can be configured using a series of menus accessed through the indicator front panel when the
indicator is in setup mode.
Table 3-1 summarizes the functions of each of the main menus.
3.3 Menu Structures and Parameter Descriptions
The following sections provide graphic representations of the 320IS menu structures. In the actual menu structure,
the settings you choose under each parameter are arranged horizontally. To save page space, menu choices are
shown in vertical columns. The factory default setting appears at the top of each column.
Most menu diagrams are accompanied by a table that describes all parameters and parameter values associated
with that menu. Default parameter values are shown in bold type.
To exit configuration mode, with the display showing CONFIG., press the ZERO key to scroll up.
Menu Menu Function
CONFIG Configuration Configure grads, zero tracking, zero range, motion band, overload, tare function, push button
enable, and digital filtering parameters.
FORMAT Format Set format of primary and secondary units, display rate.
CALIBR Calibration Calibrate indicator. See Section 4.0 on page 33 for calibration procedures.
SERIAL Serial Configure EDP and printer serial ports.
PROGRM Program Set regulatory mode, unit ID, auto zero, consecutive number values, and battery standby.
PFORMT Print Format Set print format used for gross and net tickets. See Section 6.0 on page 43 for more
information.
DIGIN Digital Input Assign digital input functions. See Section Figure 3-7. on page 30 for more information.
ALGOUT Analog Output Configure analog output. See Section 3.3.7 on page 31 for analog output configuration.
VERS Version Display installed software version number.
Table 3-1. 320IS Menu Summary
Comments to this Manuals