Rice Lake DeckHand Service Manual

43978 Rev ADeckHandPortable Floor ScaleInstallation andService ManualTM

6 DeckHand Installation Manual3.0 Service Information3.1 Troubleshooting Guide3.2 Periodic MaintenanceTwo important spaces—between the platform side a

Service Information 73.3 Load Cell ReplacementDisassembly1. Remove the four locknuts and washers that secure the platform to load cell channels. Lift

8 DeckHand Installation ManualFigure 3-1 DeckHand Junction Box CutawayReplacing Deck PlatformPut the scale flat on the floor and set the platform on

Service Information 9Corner TrimmingAll DeckHand scales are delivered with the junction box trimmed, but re-trimming to equalize loading is necessarya

10 DeckHand Installation Manual3.4 Installing Protective ClamshellsStainless steel clamshells—load cell protectors—are mounted around the load cells t

Service Information 113.6 Ramps and Replacement Load CellsFigure 3-4 Scale and Ramp DimensionsW h e n attaching a ramp to a D e c k H a n d scale, pl

12 DeckHand Installation Manual4.0 Replacement PartsFigure 4-1 Replacement Parts Illustration29293031323736383513940432241232528502719646891011121315

Replacement Parts 13Ref. DescriptionPart No.Mild SteelPart N0.Stainless 1 Cable, 6-Conductor, 3 1/2 ft 15494 44187 2 Mount, Indicator, 310A 41011 4

14 DeckHand Installation ManualDeckHand Limited WarrantyRice Lake Weighing Systems (RLWS) warrants that all RLWS equipment and systems properly instal

2013 Rice Lake Weighing SystemsPN 119071 01/13

tNATIONALCONFERENCEtONWEIGHTSANDMEASURESContents1.0 Introduction...

ii DeckHand Installation Manual

Introduction 11.0 Introduction The DeckHand™ Portable Floor Scales are fully electronic, NTEP-certified floor scales allowing one-personportability on

2 DeckHand Installation ManualFailure to heed may result in serious injury of death.DO NOT allow minors (children) or inexperienced persons to operate

Installation 32.0 Installation OverviewAssembly of the scale consists of the following steps:1. Unpacking2. Assembling mast onto scale base3. Installi

4 DeckHand Installation Manual2.3 Mounting and Wiring the Mast and IndicatorAssembling Mast to BaseRemove back plate from mast. Carefully insert mast

Installation 52.5 Configuring the IndicatorRefer to the indicator manual for information on configuring the indicator for your application.If using th