Rice Lake 550-10 Installation Guide download pdf (Page 19)

Here you see the USB connector peaking through the back of the DRO

enclosure. The probe is pointing to the program pushbutton. You can also see

my separate electronic edge finder and tachometer jacks in the upper left hand

corner. I chose to not add connectors for Edge 2 or Flex 1 at this time. Flex 1

used to be called Tach 1.

15. [ ] If you bought the Lite DPU-550 version, then put the existing cables

back on the DRO-350 board in their original position. If desired, install a new

jack for the electronic edge finder input and plug into Edge 1 socket on the

DPU-550. Then skip to step 24.

16. [ ] If you bought the full DPU-550 version, then locate the power

connector attached to the enclosure. Trace the wires and find the two pin

female connector.

17. [ ] Look at the end of the DPU board furthest from the PIC connector. At

the corner you will see one connector marked “out”. Next to it is an identical

connector marked “in”.

Page 19 of 27

“out”

“in”

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

No comments

Rice Lake 550-10 Installation Guide Page 19