Rice-lake Combination System - Precision Loads PL9710 Indica User Manual download pdf (Page 17)

PL9710 Installation Manual - Using the Serial Ports 13

6.3 Connecting a Wireless Remote

Display System

The transmitter for a wireless remote display system is

connected to the COM3 port on the back of the

PL9710

indicator. The red power wire attaches to the 12VDC

positive (+) terminal, the ground wire attached to the

COM3 GND terminal, and the signal wire attached to

the COM3 TXD terminal. Consult the remote display

operator’s manual for the ground and signal wire

colors.

For the printer to operate properly, the COM3

baud rate must be set to 9600 baud (Step 5 of

the previous section).

The COM3 serial port should be set for continuous output

(Step 8 of the previous section) if a wireless remote display

is connected. Continuous output will allow the remote

display to show the same as the indicator’s weight display.

Figure 6-2. Wireless Remote Display Connections

6.4 Connecting a Remote (Scoreboard)

Display

A remote hard-wired display, sometimes called a

scoreboard display, is connected the same as described

above for the transmitter of a wireless remote display.

Note

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

No comments

Rice-lake Combination System - Precision Loads PL9710 Indica User Manual Page 17